When the chiller is molded, the clamping force required is different depending on the type of raw materials and the size and shape of the molded product. When adjusting the mold, adjust the minimum clamping force according to the actual needs. In this way, power consumption can be saved and the life of the machine can be significantly extended.
Industrial chillers must pay attention to the safety of the machine when using the machine. Please check the safety of the machine, the safety ram and the safety door at the beginning of each operation. During the operation of the machine, remember not to put your hand into the clamping mechanism. When taking the product, be sure to open the safety door, and then close the safety door after confirming personnel safety and no foreign matter in the mold. In addition, the hand cannot extend between the nozzle and the mold gate during operation. When repairing the mold, turn off the oil pump motor.
The screw chiller has the advantages of high efficiency, good performance, low noise, low vibration, energy saving, high reliability and long service life. According to customer needs and cold tonnage size, single or multi-machine combination. The compressor can change according to the load and automatically alternately rotate to balance the running hours of each compressor, which greatly prolongs the service life of the chiller. Use industry:
1. The size of the chiller model for the injection molding machine is used to cool the mold of the injection molding machine, that is, a 25HP chiller is required. When used for cooling other equipment, it depends on the specific flow rate of the cooling water circulation.
2. The selection of the insulated water tank and water pump of the chiller is sometimes based on the actual situation of the customer's factory. The open type chiller, when the external water pump is used, the pump power requirement is the same as that of the same type of box chiller.
3. The temperature of the chiller backwater should not be higher than 40 degrees. The higher the return water temperature, the greater the damage to the compressor.
