1. The location of the purification project should be determined according to the following requirements and after comparing technical and economic plans.
1. It should be in an area with low atmospheric dust and harmful gas concentration and good natural environment.
2. Keep away from railways, wharfs, airports, traffic arteries, factories, storage yards, and storage yards that emit large amounts of dust and harmful gases that have serious air pollution, vibration or noise interference. If it cannot be far away from the source of serious air pollution, it should be located on the upwind side of the maximum frequency wind, or on the downwind side of the annual minimum frequency air flow.
3. It should be arranged in the area where the environment is clean, and the flow of people and logistics does not pass or seldom pass.
2. For the location selection of the purification workshop with micro-vibration control requirements, the vibration influence of the surrounding existing vibration sources should be actually measured, and it should be determined after analysis and comparison with the allowable vibration value of precision equipment and precision instruments.
3. The distance between the dust-free workshop and the main traffic road should be greater than 50m.
4. A circular fire lane (traffic roads can be used) should be set around the dust-free workshop. If there are difficulties, fire lanes can be set along the two long sides of the plant.
5. The road surface around the dust-free workshop should be made of materials with good overall performance and less dust.
6. Greening should be carried out around the dust-free workshop, lawns can be paved, plants harmful to production should not be planted, and fire fighting operations should not be hindered.
If you are interested in the clean room central air conditioner , please feel free contact :
